![]() You can stream audio wirelessly to G-70W from up to 33’ away using your iPhone, iPad, iPod, Android, laptop, or other A2DP Bluetooth enabled device. Notes: Saving a new station preset in the same position as a previously saved station will replace the previously stored station for that preset number. Tuning begins from the lowest frequency and save it in ascending order. Press and hold the PLAY/PAUSE button, then it will start automatic presetting and saving radio station.Or repeatedly press the PRESET button until the desired preset number appears in the display and the station tunes in. Then press TUNE UP or TUNE DOWN button to select the desired preset number. First select AM or FM radio mode, then press the PRESET button and the “P#” will show on the LCD display. There has two ways to recall a preset station.Press the PRESET button again to confirm the setting and the station will be saved into memory. Press the TUNE UP or TUNE DOWN button to select a preset number (01- 20).To increase FM reception sensitivity, fully extend the Telescopic Antenna and rotate to obtain the best reception of possible station. Repeat these steps for up to 20 presets, as desired.Press the TUNE UP or TUNE DOWN button to select a preset number (01- 20).Press the PRESET button again to confirm the setting and the station will be saved into memory.“P” will appear and “#” (the preset number) will blink on the LCD display. Press and hold the PRESET button to create a preset for the current station. ![]() ![]() To preset a radio station to memory, first follow the previous steps to select AM or FM radio mode and tune in the desired station.SETTING RADIO PRESETS Manual presetting radio station: If AM reception is weak, change the position of the unit until the internal antenna picks up the strongest signal. The AM antenna is located inside the cabinet of the unit. Repeat this process until the desired station appears on the LCD display. The tuner will search and stop on the next strongest station signal it finds. For auto tuning, press and hold the TUNE UP or TUNE DOWN button until the display starts to scan, then release the button.For manual tuning, repeatedly press the TUNE UP or TUNE DOWN button to manually adjust the tuning on the LCD display until the desired station appears.Press AM or FM button to select AM or FM band, the radio mode indicator displays.Press and hold the POWER ON/STAND BY button to turn on the unit, the LCD backlight turns on.Press the VOLUME + or VOLUME – buttons to increase or decrease the volume. Charge the rechargeable battery at least biannually VOLUME CONTROL.Rechargeable batteries have a limited number of charge cycles.Actual battery life varies with use, settings, and environmental conditions.The battery is internal and cannot be replaced.Please refer to the battery level bar of the battery level indicator on the display for the battery percentage. Alkaline, Rechargeable and Carbon-zinc) or old batteries with fresh ones. Do not mix different types of batteries together (e.g.Do not try to recharge a battery not intended to be recharged – it can overheat and rupture (Follow battery manufacturer’s directions.).If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage.A reversed battery may cause damage to the device. Be sure to follow the correct polarity when installing the batteries as indicated in the Battery Compartment.Use only the size and type of batteries specified.Replace only with the same or equivalent type. Warning – Danger of explosion if batteries are incorrectly replaced.Alkaline batteries are recommended for the longest playing time. Close the battery door and rotate clockwise the lock until it is tightened firmly.Unlock the battery door on the back of G-70W by rotating anticlockwise the lock Insert three (3) “AA” batteries following the correct polarity indicated in the battery compartment.When the battery is fully charged, the battery level bars The battery icon on the display will appear and the battery level bars will be moving to indicate charging process. To recharge the built-in battery: Connect G-70W with a USB charging adapter or any other USB charging device through the supplied Type-C USB charging cable. The G-70W is designed to operate using the built-in rechargeable battery or using 3 x AA batteries (not included). G-70W Bluetooth Speaker with Weather Radio.41 Related Posts G-Project G-70W Bluetooth Speaker User Guide
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |